| Microphone/Line Inputs |
Four balanced. Phantom power available |
| Preamp Gain (total path) |
+25dB to +70dB |
| Line Input Impedence |
20K Ohms, balanced to ground |
| Common Mode Rejection |
Mic Input/45dB Gain = 100dB, Line In = >70dB |
| Freq Response (All Paths) |
20-20KHz, +/- 0.5 dB |
| Microphone Channel EIN |
125 dB, bandwidth-limited to 25KHz |
| System Signal/Noise |
100 dB below peak level, bandwidth-limited to 25KHz |
| A-D and D-A Conversion |
24-bit, 48KHz |
| Digital Processing |
24-Bit, 48KHz, via dual-core 32-bit DSP |
| IFB Outputs |
2 channel wet RTS-format or single-channel dry +4dB nom. |
| IFB DC Current |
Sufficient to power two RTS IFB beltpacks |
| PL Interface |
2 channel wet RTS-format. DC current to support 3 beltpacks |
| PL Trans-hybrid Loss |
Greater than 55 dB |
| Remote Control |
ADX-2400 or 3200, Windows PC, Rear-panel RS232, or GPI |
| Network Transmit Channels |
Six: Mic1, Mic2, Mic3 (TB1), Mic4 (TB2), PL1-TX, PL2-TX |
| Network Receive Channels |
Six: IFB1, IFB2, PGM1, PGM2, PL1-RX, PL2-RX. |
| Front Panel Switches |
Two-digit rotary ID switches. No other panel controls |
| System Addressing |
Two-digit rotary switches. Address 01-99 |
| Network Interface |
100baseT Ethernet (redundant RJ45 ports) |
| Ethernet Bandwidth Required |
Approximately 8 megabits/sec each direction per ADX-140 |
| Power Requirements |
48 Volts, 255 MA with no beltpacks. 350 MA with four beltpacks, or AC (95-250V/50-60Hz) |
| Cabinet Dimensions |
19" Wide, 9" Deep, 1.75" High. (1 Rack Unit) |
| Weight |
Approx. 3 Pounds |
